Craft on the Run: Cards With Jenny - A4 Dreamland Collection Pack

CARDS WITH JENNY - DREAMLAND

Hello Again Chit Chatters

Jenny with you again to share three cards using the gorgeous A4 Dreamland Collection Pack. In addition to the pack all that is required is a pair of scissors, some glue or double sided tape, foam mounting tape and some blank cards. I have embellished one of the cards with some flowers however this is optional. Stickers can be used for the sentiments or these can be die cut as I have done if you have these available.

All products can be purchased from Craft on the Run.

Card 1

For this card I cut the wall and doors from one of the sheets. I then cut the doors down the middle, across the bottom and around the curve at the top so that they would open.

From the front sheet in the pack I cut out the animals as pictured above. I also cut some flags from one of the sheets. These were then adhered to the card with the animals being placed underneath and the flags above so that they can be seen through the open doors.

Add a sentiment to the card by using either stickers or die cuts and also add pearls or similar on the door knobs.

Your card is now complete.

Card 2

Choose a background paper and mount to the card leaving a narrow border around the edge. Cut out the elephant from one of the sheets. From the other sheet cut the elephants face and trunk as one piece and both feet. Also cut some flags for the top of the card.

Adhere the flags to the top of the card. Using Foam Mount Tape mount the elephant to the card. Also using Foam Mount Tape mount the face and trunk over the top and give the trunk a bit of a curl for added dimension. Mount the feet on top using Foam Mount Tape also.

Add a sentiment to the card either using a die cut or stickers.

Your card is now complete.

Card 3

Choose a background paper and mount to the card leaving a narrow border around the edge. Cut out the bear from one of the sheets. From this bear cut out the nose to mount on top of the face for added dimension.

TIP

As this layer will be covered you won't see that it has been cut out.

From the other sheet cut the bear's face and tummy.

Using Foam Mount Tape mount the bear to the card. Also using Foam Mount Tape mount the face and tummy on the top of the bear. Then mount the nose on top of the face using Foam Mount Tape also .

Add some flowers to the top left of the card and add a sentiment either using a die cut or stickers. If desired you can also use clear Wink of Stella for some extra sparkle.

Your card is now complete.

I hope you have enjoyed my blog and find some inspiration and find time to create.

Until next time.

Products for these cards can be found below.